What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 01:21
2024–10–14 [Omar Gharbi Omar Gharbi ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
One is “what exactly is in a ‘surge protector’ ? ”
Because the load is inductive, the current lags the voltage.(by a bit).
so, what happens?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Inflation Expectations Decline; Labor Market Expectations Improve - Federal Reserve Bank of New York
This is where this question deviates from being a 'generic' question, and becomes more specific.
In schematic diagrams this is the symbol for a fuse:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is where the MOV conducts again, and dissipated the energy.
2024–10–10[John johnson John Johnson ]
[old diagram got deleted by accident]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
but this device (an Inductor) … impedes the rapid changes in the current.
Barnstars:
Neuroscientists just discovered a fascinating fact about the grooves in your brain - PsyPost
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–16 [ OO OLAOYE OYEBODE ]
But… the neutral is now “floating” because of the 1 ohm resistance.
New COVID-19 variant detected in Washington state. Here’s what to know - The Seattle Times
A fuse is a non-resetable over current circuit protector.
There are three different concepts here that are getting confused.
Upvotes:
What does a fuse do?
The MOV will conduct when the voltage exceeds 50% of line voltage.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Xbox sale round-up June 3, 2025 - DLC - TrueAchievements
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At least they know the answer if they wanted it.
Which document should be pointed out to a holocaust denier?
Edit 2024–10.
What is lightning?
So, the voltage could go up to 500 volts, and the fuse will not open up.
Could This Diet Be the Key to Preventing Alzheimer's and Dementia? - bestlifeonline.com
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
a photo is worth a thousand words.
It also is a device that limits the change in current flow.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is 'the assistant's answer'
Apple brings Apple Intelligence to the iPhone screen at WWDC 2025 - TechCrunch
First Sentence:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Here is a simplified AC power diagram.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Now when you have a certain ac resistance, then a current flows in a loop.
Ultra-thin lenses halve incident wavelength to make infrared light visible - Phys.org
(Dc diagram shown, AC is similar).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
[image of Common-mode choke]
This device then solves the entire problem.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
but I think this circuit , shows a few more pieces.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
These devices are installed between the “hot” and “neutral” and protective ground.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
I post the exact comment here.
One
The other is “what does a “fuse” do?”
But it can get overloaded, and no longer works.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
For this case there are devices called Metal oxide varistors (MOV).
the problem then depends on "how fast does the fuse operate?".
These are simplified answers to the original question, and does not change anything I wrote above.
what exactly is a ‘surge’ protector?
It seems Mohan does not understand the difference between a comment and an Answer.
eight
nine
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A circuit breaker is similar, but is resettable.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
He then asserts :
An AC voltage/ current source, and an ac inductive load.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
The third is lightning and “how it gets conducted into a home.”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
He then describes the function of a fuse.
The bolt then partially travels down the line to your home.
He then describes Rainy Season and Lightning.
This one hit behind the barn.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
At one ohm, the resistor has a maximum of 1 watt power.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
There are two important concepts here.